The Veritas router table is hand hammered to put a slight crown at the
middle. When the fence is attached, or you are putting downward pressure on
the stock, the table deflects to flat. With its inherent crown, I might not
use it for an extension. Besides, many times while I am routing something,
I need to rip another piece on the table saw. You might lose your setup
with the router table in the extension.
Preston
"Bri" <[email protected]> wrote in message
news:[email protected]...
> I'm looking for tips and/or info from anyone who has the veritas
> Router table mounted in their Tablesaw extension.
> Thanks in advance for any replies.