Millimeters = equals degrees with the most basic vise type of
guide, bought mine at a Rockler store. The instructions only
give the following:
Chisel projection: 30mm = 30º / 40mm = 25º
Plane iron projection: 38mm = 30º / 50mm = 25º
Time for 1º more for the micro bevel of either, can anyone tell
me how many less millimeters to subtract from the projections?
--
Alex
cravdraa_at-yahoo_dot-com
not my site: http://www.e-sword.net/
It ought to me accurate enuf to interpolate:
-2 mm for chisels and -2.5 mm for plane irons should give you a 1degree
change.
Walt C
"AAvK" <[email protected]> wrote in message
news:Qi1Xd.8941$qf7.416@fed1read03...
>
> Millimeters = equals degrees with the most basic vise type of
> guide, bought mine at a Rockler store. The instructions only
> give the following:
>
> Chisel projection: 30mm = 30º / 40mm = 25º
> Plane iron projection: 38mm = 30º / 50mm = 25º
>
> Time for 1º more for the micro bevel of either, can anyone tell
> me how many less millimeters to subtract from the projections?
>
> --
> Alex
> cravdraa_at-yahoo_dot-com
> not my site: http://www.e-sword.net/
>