Or get a reamer and slowly ream it.
On 4/2/2012 5:29 PM, [email protected] wrote:
> On Apr 2, 5:17 pm, John Doe<[email protected]> wrote:
>> I would like to press a slice of UHMW tubing over a 22 mm outer
>> diameter bearing. Unfortunately McMaster Carr does not have 7/8
>> inner diameter tubing, they go from 3/4 to 1.
>>
>> John Doe<[email protected]> wrote:
>>> How about using a heat gun? Will a short 1/4 inch piece of 3/4
>>> inch inner diameter UHMW tubing stretch to nearly 7/8 inches?
>>
>>> Thanks.
>
> How about drilling out a 3/4 id to 7/8? Or using a round file?
>
> Dan
On Apr 2, 5:10=A0pm, John Doe <[email protected]> wrote:
> How about using a heat gun? Will a short 1/4 inch piece of 3/4 inch
> inner diameter UHMW tubing stretch to nearly 7/8 inches?
>
> Thanks.
On Apr 2, 5:17=A0pm, John Doe <[email protected]> wrote:
> I would like to press a slice of UHMW tubing over a 22 mm outer
> diameter bearing. Unfortunately McMaster Carr does not have 7/8
> inner diameter tubing, they go from 3/4 to 1.
>
> John Doe <[email protected]> wrote:
> > How about using a heat gun? Will a short 1/4 inch piece of 3/4
> > inch inner diameter UHMW tubing stretch to nearly 7/8 inches?
>
> > Thanks.
How about drilling out a 3/4 id to 7/8? Or using a round file?
Dan
I would like to press a slice of UHMW tubing over a 22 mm outer
diameter bearing. Unfortunately McMaster Carr does not have 7/8
inner diameter tubing, they go from 3/4 to 1.
John Doe <[email protected]> wrote:
> How about using a heat gun? Will a short 1/4 inch piece of 3/4
> inch inner diameter UHMW tubing stretch to nearly 7/8 inches?
>
> Thanks.
>