I notice that the Delta TS350 has shorter cutting depths, compared to
other saws. Even compared to the TS300. Since max 90deg depth is only
2 7/16" and max 45deg depth is only 1 11/16", will this be a problem if
I get this saw to start in woodworking? I'm thinking about building a
Little Shop Mark II for this or a comparable Ridgid saw.
Mike
<[email protected]> wrote in message
news:[email protected]...
>I notice that the Delta TS350 has shorter cutting depths, compared to
> other saws. Even compared to the TS300. Since max 90deg depth is only
> 2 7/16" and max 45deg depth is only 1 11/16", will this be a problem if
> I get this saw to start in woodworking? I'm thinking about building a
> Little Shop Mark II for this or a comparable Ridgid saw.
>
Don't know the saw, but except for resawing, I have never cut anything over
2".