Not really...
However, if you match grain, are VERY precise with your cuts, and sand
really smooth, you might make it less noticable.
Scott Cadreau wrote:
> I have a project that I need to butt two pieces of stock together but
want
> to stain the end product. Is there anything I can do to eliminate
the
> visibility of the seam?
>
> Thanks,
>
> Scott
Paul,
Thank you. That will work for this application.
Scott
"Paul O." <[email protected]> wrote in message
news:[email protected]...
>
> "Scott Cadreau" <[email protected]> wrote in message
> news:[email protected]...
>>I have a project that I need to butt two pieces of stock together but want
>>to stain the end product. Is there anything I can do to eliminate the
>>visibility of the seam?
>>
>> Thanks,
>>
>> Scott
>>
> Don't know if it'll work in your case, but I have taken a router bit,
> possibly a v shaped bit(chamfer bit) and run along a seam to make it look
> like part of the design.
> --
> Paul O.
> [email protected]
>
"Scott Cadreau" <[email protected]> wrote in message
news:[email protected]...
>I have a project that I need to butt two pieces of stock together but want
>to stain the end product. Is there anything I can do to eliminate the
>visibility of the seam?
>
> Thanks,
>
> Scott
Put a strip of duct tape over it.
"Scott Cadreau" <[email protected]> wrote in message
news:[email protected]...
>I have a project that I need to butt two pieces of stock together but want
>to stain the end product. Is there anything I can do to eliminate the
>visibility of the seam?
>
> Thanks,
>
> Scott
>
Don't know if it'll work in your case, but I have taken a router bit,
possibly a v shaped bit(chamfer bit) and run along a seam to make it look
like part of the design.
--
Paul O.
[email protected]
You might be able to "fake it" by trying to use a combination of glaze
and stain. If you are really good with a glaze and a dry brush you
might be able to create some fake grain. This works OK on darker
finishes, but if you're talking about a light stain, I'm not sure you
can do much more than try to match the grain in alignment.
On Thu, 10 Mar 2005 14:21:52 -0700, "Scott Cadreau"
<[email protected]> wrote:
>I have a project that I need to butt two pieces of stock together but want
>to stain the end product. Is there anything I can do to eliminate the
>visibility of the seam?
>
>Thanks,
>
>Scott
>
Edwin Pawlowski wrote:
> "Scott Cadreau" <[email protected]> wrote in message
> news:[email protected]...
>
>>I have a project that I need to butt two pieces of stock together but want
>>to stain the end product. Is there anything I can do to eliminate the
>>visibility of the seam?
>>
>>Thanks,
>>
>>Scott
>
>
> Put a strip of duct tape over it.
>
>
Made me LOL.
j4