I've painted quite a bit with an airless. The best cost-value I have
ever seen was when I purchased a used Wagner sprayer, threw away the
gun and purchased a Graco gun. The wagner is just a pump, all the
work is done by the gun-so buy the best. Carefully study the nozzle
types of any brand and match the orfice to the type of paint. Always
use a cone filter or a bag filter on the paint just before spraying.
They are cheap, work well, take up just a minutes and collect the
darnest crap and can be cleaned and reused. Leave the filter on the end
of the suction pipe of the wagner, and always clean out the gun filter.
(it's located in the barrel of the handle). Practice on a flat wall and
be very careful spraying in a corner where the paint load builds up
VERY quickly. One last comment- Allow the first coat to dry overnight
at least, before recoating. Using latex, the paint forms a skin which
appears dry but a quick second coat dissolved that skin and then the
whold lot runs.
Lowes and if you're desperate, Homo Depo, usually have used sprayers on
hand although you may have to ask at the desk.
Jim
Any of the Graco airless sprayers will spray the two houses you need to
paint and will last way beyond that. I have painted 20+ houses with the
$300.00 Graco from Home Depot. You will want another 50' of hose which runs
about $1.00 per foot.
As for HVLP's you can buy a low end from Rockler or Wagner in the $100.00
range. If you want a real good starter unit go here:
http://www.lemmer.com/t55-hvlp-turbine.htm This is a GREAT starter unit at a
good price.
Have fun,
cm
"sumdume" <[email protected]> wrote in message
news:[email protected]...
> What are the pros and cons of airless High Volume Low Pressure
> sprayers?
>
> I have to apply paint to 2 houses in the next few months. I would like
> to get a good sprayer that can also be used for wood working.
>
> Are there any sprayers that stand out as good values or definite stay
> away from model?
>
> Thanks
>
HVLP and airless are two different spray systems. An airless system is great
for painting houses, but not adjustable enough for wood finishes. An HVLP is
great for wood finishes but not enough output to efficiently paint a house.
cm
"sumdume" <[email protected]> wrote in message
news:[email protected]...
> What are the pros and cons of airless High Volume Low Pressure
> sprayers?
>
> I have to apply paint to 2 houses in the next few months. I would like
> to get a good sprayer that can also be used for wood working.
>
> Are there any sprayers that stand out as good values or definite stay
> away from model?
>
> Thanks
>
"sumdume" <[email protected]> wrote:
>What are the pros and cons of airless High Volume Low Pressure
>sprayers?
>
>I have to apply paint to 2 houses in the next few months. I would like
>to get a good sprayer that can also be used for wood working.
>
>Are there any sprayers that stand out as good values or definite stay
>away from model?
I'm a newbie in the spraying area as well, but I think you are talking
about two different things. One is an airless sprayer, which is more
of a house painting tool. They range from ~$100 Wagner power painters
Where the pump, paint container and spray head are built into a single
unit to units with a separate pump sending pressurized paint through a
hose to the gun.
An HVLP is NOT airless, but has either a high-volume low-pressure
source of air (think of the exhaust from a vacuum motor, or in a
conversion gun, converts the higher pressure air from a compressor to
the lower pressure/higher volume used for this type of spraying. HVLP
is better for typical wood-working finishes, not for latex paint.
--
Alex -- Replace "nospam" with "mail" to reply by email. Checked infrequently.
If you are going to paint houses, you will need to go with an airless high
pressure system. Unfortunately, these don't work too well for woodworking
especially in a closed space like a shop, way too much over spray and pump a
lot of paint through them. HVLP's are great for woodworkers as there is
little overspray involved and are great for many finishes except latex which
is too thick for most applications unless thinned..
"sumdume" <[email protected]> wrote in message
news:[email protected]...
> What are the pros and cons of airless High Volume Low Pressure
> sprayers?
>
> I have to apply paint to 2 houses in the next few months. I would like
> to get a good sprayer that can also be used for wood working.
>
> Are there any sprayers that stand out as good values or definite stay
> away from model?
>
> Thanks
>
sumdume wrote:
:: What are the pros and cons of airless High Volume Low Pressure
:: sprayers?
::
:: I have to apply paint to 2 houses in the next few months. I would
:: like to get a good sprayer that can also be used for wood working.
::
:: Are there any sprayers that stand out as good values or definite stay
:: away from model?
::
:: Thanks
This the kind of thing you mean ?
http://www.axminster.co.uk/product.asp?pf_id=21218&name=hvlp&user_search=1&sfile=1&jump=4
Chris.
"mrbingley" <[email protected]> wrote:
>This the kind of thing you mean ?
>
>http://www.axminster.co.uk/product.asp?pf_id=21218&name=hvlp&user_search=1&sfile=1&jump=4
>
>Chris.
Looks like the same unit sold in the US by Harbor freight, Rockler,
and Woodcraft: http://www.woodcraft.com/family.aspx?familyid=5853
Interesting pricing strategy--looks like it is 99, independent of the
unit of currency. Maybe we need to find a Canadian supplier of this
unit<g>
--
Alex -- Replace "nospam" with "mail" to reply by email. Checked infrequently.