Jim Smith wrote:
>
> Any suggestions on how to eliminate splinter/tearout when routering oak?
1. Take partial cut(s) to final depth
2. Make sure bit is <sharp> (not some cheap pos)...
3. Higher rotational speed may help if it's a small diameter bit
4. Try to control the grain direction in the piece your routing and use
straight-grained stock
HTH...
And a "backer board" if at all possible...
Duane Bozarth wrote:
> Jim Smith wrote:
>
>>Any suggestions on how to eliminate splinter/tearout when routering oak?
>
>
> 1. Take partial cut(s) to final depth
> 2. Make sure bit is <sharp> (not some cheap pos)...
> 3. Higher rotational speed may help if it's a small diameter bit
> 4. Try to control the grain direction in the piece your routing and use
> straight-grained stock
>
> HTH...
--
Will
Occasional Techno-geek
On Sun, 06 Mar 2005 19:44:11 -0500, Jim Smith wrote:
> Any suggestions on how to eliminate splinter/tearout when routering oak?
We just had a long discussion on this. Check out:
<http://www.google.ca/groups?hl=en&lr=&ie=UTF-8&threadm=x8dSd.2497%24Ba3.1220%40newsread2.news.atl.earthlink.net&rnum=1&prev=/groups%3Fas_q%3Drouter%26safe%3Dimages%26ie%3DISO-8859-1%26as_ugroup%3Drec.woodworking%26as_uauthors%3Dpalmer%26as_scoring%3Dd%26lr%3D%26num%3D100%26hl%3Den>
--
Luigi
Replace "nonet" with "yukonomics" for real email
www.yukonomics.ca/wooddorking/humour.html
www.yukonomics.ca/wooddorking/antifaq.html
"Jim Smith" <[email protected]> wrote in message
news:[email protected]...
> Any suggestions on how to eliminate splinter/tearout when routering oak?
>
>
In addition to the other suggestions, sometimes a little climb cut on the
back end will be enough to eliminate the tearout when you make the cut in
the proper direction. Use care and a very light touch.