Swingman wrote:
>
http://www.engadget.com/2006/06/29/how-to-build-your-own-cnc-machine-part-1/
>
>
http://www.engadget.com/2006/07/04/how-to-build-your-own-cnc-machine-part-2/
>
> Eat your heart out, Morris! :)
>
I built one in 1995 for my college senior project. Used an old IBM XT
system board that I bought for $1, stepper motors from dot matrix printers,
threaded rod like that one and some drawer rail bearings I found surplus.
Had to put my code in via a 5&1/4" floppy but it worked.
Swingman (in [email protected]) said:
|
http://www.engadget.com/2006/06/29/how-to-build-your-own-cnc-machine-p
art-1/
|
|
http://www.engadget.com/2006/07/04/how-to-build-your-own-cnc-machine-p
art-2/
|
| Eat your heart out, Morris! :)
It looks like a good learning project. I lean toward beefier machines
with more spindle power - but this is a good confidence-building
exercise...
Why don't you build one?
--
Morris Dovey
DeSoto Solar
DeSoto, Iowa USA
http://www.iedu.com/DeSoto
Swingman (in [email protected]) said:
| "Morris Dovey" wrote in message
|
|| Why don't you build one?
|
| Wish I had the time, and I don't know how much use I would get out
| of a dremel cnc, but I thought you'd get a kick out of it.
|
| I am going to follow the segments in any event, just in case ...
Good enough. The basic principles remain the same regardless of
machine or spindle size.
First caveat: There's a minimum "cover charge" that applies to these
things - and while you can substitute time for money for a significant
part of the project, even a little machine like the one shown will
cost between $1K and $2K (in some mixture of $ and hours) before you
can do anything with it.
As you follow the developments, look for elements that you're
confident you can reasonably make/do/scrounge yourself - and recognize
those that you'll need to spend for.
Second caveat: Machine design _can_ be art. Machine fabrication
_cannot_ be art. Plan to spend at least as much time building fixtures
to produce the parts as you plan to spend making the parts themselves.
Every axis of motion will need a minimum of two (and more probably
three) parallel components - and for these "almost perfect" isn't good
enough.
Final caveat: The most recently-built machine is _never_ good enough.
:-D
--
Morris Dovey
DeSoto Solar
DeSoto, Iowa USA
http://www.iedu.com/DeSoto