Senco sent me a restrictive trigger for my SNS45 stapler. Restrictive
trigger guarantees that not more than one staple will be shot upon one
pull of the trigger.
I found one page with instruction to be somewhat lacking, and created
a photo tutorial that shows how to install the trigger.
Doing so is not very complicated, but there are some gotchas that one
needs to be aware of, that I tried to highlight.
http://igor.chudov.com/projects/misc/Installing-Restrictive-Trigger-On-Senco-SNS45-Nailer/
i
Very cool. I thought I had the exact same stapler but I actually have
the 41. Same manual so I assume the restrictive trigger I ordered will
be the same.
I've run maybe 20-30 loads of staples through this in the last week
and like Senco always does, runs like a charm. The Senco folks were sp
great. The woman in the call center had been with the company for many
years and was super knowledgable and helpful and sent the free
trigger.
On Jun 21, 8:52=A0pm, Ignoramus12887 <ignoramus12...@NOSPAM.
12887.invalid> wrote:
> Senco sent me a restrictive trigger for my SNS45 stapler. Restrictive
> trigger guarantees that not more than one staple will be shot upon one
> pull of the trigger.
>
> I found one page with instruction to be somewhat lacking, and created
> a photo tutorial that shows how to install the trigger.
>
> Doing so is not very complicated, but there are some gotchas that one
> needs to be aware of, that I tried to highlight.
>
> http://igor.chudov.com/projects/misc/Installing-Restrictive-Trigger-O...
>
> i
"Ignoramus12887" <[email protected]> wrote in message
news:[email protected]...
> Senco sent me a restrictive trigger for my SNS45 stapler. Restrictive
> trigger guarantees that not more than one staple will be shot upon one
> pull of the trigger.
>
> I found one page with instruction to be somewhat lacking, and created
> a photo tutorial that shows how to install the trigger.
>
> Doing so is not very complicated, but there are some gotchas that one
> needs to be aware of, that I tried to highlight.
>
> http://igor.chudov.com/projects/misc/Installing-Restrictive-Trigger-On-Senco-SNS45-Nailer/
>
> i
We had to modify an 18 ga. 1/4" crown stapler to shoot a staple into the
bottom of a 1/2" deep hole. The punch had to stick out of the nose buy 1/2"
at the bottom of the stroke. We redesigned the magazine, sectioned a large
portion of it out and moved it up toward the gun. We modified the nose too.
After looking at all the commercial models, we settled on a $20 Harbor
Freight model and bought 6 of them so we won't have to reinvent the wheel.