Just acquired my first "real" upholstery hammer - long thin head, with
a curve to it. This much is obvious, for setting tacks in rebates,
without the awkward "square push" of a square-faced Warrington or pin
hammer.
But what's the other end for ? Now a magnetic tack holder I can
understand, but this is the "claw" pattern. Is it really meant to
hold tacks when they're being inserted, or is it just a carrier for a
handful, instead of putting them in your mouth ?
--
Die Gotterspammerung - Junkmail of the Gods
On Sun, 18 Jul 2004 23:34:08 +0100, Andy Dingley <[email protected]> wrote:
>
> But what's the other end for ? Now a magnetic tack holder I can
> understand, but this is the "claw" pattern.
Did it used to have a magnet on it maybe? Those magnets don't last
long, as the impact makes 'em non-magnets after not long at all.
> Is it really meant to
> hold tacks when they're being inserted, or is it just a carrier for a
> handful, instead of putting them in your mouth ?
Put a tack on it, tap it in just far enough to hold, flip 'er over and
pound it in.
On Sun, 18 Jul 2004 18:35:27 -0500, Unisaw A100 <[email protected]>
wrote:
>My Grandfather was an upholsterer and he'd taught my Dad
>bits of the trade. Anyway, the hammer I got handed down was
>my Dad's.
Same here. My grandfather upholstered for the old theaters as well as
other jobs. No kidding now, his arms were so strong he could pull the
webbing without a stretcher tool, just by hand. My son now has the
hammer. I'll ask him to send a picture if he can get hold of a
digital camera.
Bill.
My Grandfather was an upholsterer and he'd taught my Dad
bits of the trade. Anyway, the hammer I got handed down was
my Dad's. It has a head 5 5/8" long with a sweet arc to it
(when viewed from the side). The one end is solid and 1/2"
in diameter at the striking surface. The other is "split"
but comes back together at the striking surface. That
surface is 5/16" diameter. This is the magnetized side.
The claw on this hammer is attached (screwed to) the heel of
the handle.
I'm not sure about the "holding tacks" part but Dad told me
that when Grandpa was at Delker Bros. (Henderson, KY) he
held his tacks in his mouth. As fast as one came out it was
tacked and there was another ready for the next ride. I
don't think Grandpa would be able to compete with pneumatics
but he put in a full day.
Besides the day job at Delker, Grandpa had a shop in the
stable behind the house and took on side jobs. When Dad was
a kid he'd help with dismantling furniture and tearing off
old fabric. Grandpa taught Dad how to scrape an old finish
off using freshly snapped glass shards. Once I asked if
Uncle Bobby ever helped in the shop. Dad's reply was,
"Yeah, just long enough to find the change (coins) that
slipped down inside the chairs and couches."
sigh...
UA100, missing his Dad and reminiscing like an old guy...