I committed to making a large island cutting board for a friend. It's
about 27" x 40". Hard-rock maple was planned ~3/4" nominal thickness.
I was just going to make it fit over the existing formica top. An apron
over the four sides would hide the existing top and keep it from sliding
around. It would seen to be nice to remove it for easy cleaning, etc.
I'm not sure how to do the apron on the end grain. A breadboard end
would leave cracks, which is not desirable. The only thing I came up
with is to glue small 1/2" pieces glued face grain to face grain on the
ends.
Another option is just to remove the formica top and replace it with the
solid wood top.
My friend mentioned an end-grain cutting board, but that seems like a
great deal of work. Extra work for the cutting, extra work for the
glue-up and alot of extra work for flattening. I don't have a wide
belt sander to flatten it.
If I did end-grain - is hardrock maple still the right wood?
Any thoughts?
Thanks!
No Spam wrote:
> My friend mentioned an end-grain cutting board, but that seems like a
> great deal of work. Extra work for the cutting, extra work for the
> glue-up and alot of extra work for flattening. I don't have a wide
> belt sander to flatten it.
It's about twice the work. You rip it and glue it like an edge-grain
board, then you plane it flat/smooth. At this point you have a
perfectly fine edge-grain board. Then you crosscut it, flip each piece,
and glue it all up again. If you make one edge strip about half the
thickness of the others, you can offset every other glue joint in one
direction to minimize the likelihood of splitting.
Best bet for flattening is a low angle jack plane...sanders leave grit
in the wood, which is bad for knife blades.
> If I did end-grain - is hardrock maple still the right wood?
Sure. I made an endgrain cutting board out of cherry and hard maple,
about 2" thick.
One thing to note...endgrain has very little strength when thin, so
you'd want to support it somehow. It will also tend to temporarily warp
if one side absorbs moisture and the other doesn't.
Chris
No Spam wrote:
> I committed to making a large island cutting board for a friend.
> It's about 27" x 40". Hard-rock maple was planned ~3/4" nominal
> thickness.
Way too thin for that size (unless*firmly* supported) for any serious
chopping. Too big for handy cutting or chopping too unless he is
doing sides of beef. YMMV.
_____________
> Another option is just to remove the formica top and replace it
> with the solid wood top.
I would.
______________
> My friend mentioned an end-grain cutting board, but that seems like
> a great deal of work. Extra work for the cutting, extra work for
> the glue-up and alot of extra work for flattening. I don't have a
> wide belt sander to flatten it.
Much better and not all that much work...
1. Cut strips of sufficient length
2. Glue strips together - enough to make one dimension of desired
finish size
3. Crosscut strips...2" would be about right.
4. Glue crosscut pieces together to make dimension #2
5. Flatten with a hand held belt or disk sander
_______________
> If I did end-grain - is hardrock maple still the right wood?
Most any fine grained & hard wood will do.
--
dadiOH
____________________________
dadiOH's dandies v3.06...
...a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico