"Gredo Goldenstein" <[email protected]> wrote in message news:<[email protected]>...
> Looking for opinions on an air nailer/pinner for shooting 1'' and less. I
> want to use it on some 3/4'' material in assembly of some raised panel
> doors. Just want to put a pin or two in each corner of rail/stile.
You might want to consider pinning once in the middle (top and bottom
rail) rather than at the corners, allow for normal wood movement.
Ideally, those panels float. Wood expands much more across the width.
If you stop it at the corners, it might warp in the middle.
As to a small pinner gizmo, perhaps one of the cheapo Harbor Freight
air guns for $20 on sale might do the trick. This is almost a craft
application. The board is quite thin there.
"Gredo Goldenstein" <[email protected]> wrote in message
news:[email protected]...
> Looking for opinions on an air nailer/pinner for shooting 1'' and less. I
> want to use it on some 3/4'' material in assembly of some raised panel
> doors. Just want to put a pin or two in each corner of rail/stile.
>
> Thanks!
Many people here seem to think the Harbor Freight Brad Nailer that often
goes on sale for around $20 works a treat!
--
Regards,
Dean Bielanowski
Editor,
Online Tool Reviews
http://www.onlinetoolreviews.com
------------------------------------------------------------
Latest 5 Reviews:
- Woodworking Techniques & Projects
- Kreg Right Angle Clamp
- Bosch 3912 (GCM12) 12" Compound Miter Saw
- Dowelmax Doweling System
- Ryobi CDL1802D Pro Series 18v Cordless Drill
------------------------------------------------------------