On Fri, 30 Dec 2005 20:43:38 -0600, with neither quill nor qualm,
<tdevery> quickly quoth:
>
>Just finished two coats with light sanding between, Do I need more coats?
Yea, about 30 ought to do it.
>Also what is rubbing out the finish?
Get Andy Charron's book on spray finishing "Spray Finishing", Tim.
If it's not in your library, www.Amazon.com has it for $11-14:
http://tinyurl.com/ckymc Spray Finishing
or
http://tinyurl.com/avb96 for Water-Based Finishes
Rubbing out is using fine sanding/rottenstone/pumice, and lots of
elbow grease to make the finish absolutely smooth and glossy.
For the non-purists, automotive rubbing compound isn't unheard of,
either. All those are for folks who like super glossy finishes.
------------------------------------------
Do the voices in my head bother you?
------------------------------------------
http://diversify.com Full-Service Web Development
"High Score" <[email protected]> wrote in message
news:[email protected]...
> "stoutman" <.@.> wrote in
> news:[email protected]:
>
>> You will need more coats than just two. If not enough coats you will
>> cut through your finish to the wood and you will need to start all
>> over again.
>>
>
> Also, lacquer does not need to be sanded between coats. The coat being
> applied partially dissolves into the coat below. That process, as well as
> the fast drying time, allow you to spray many coats fairly quickly. I
> usually wait about 30 minutes between coats. I put the spray gun in a
> cool
> place out of the sun while waiting and only clean it at the end of the
> session.
>
> -G
Agreed, but IF you get trash in the finish, a light sanding will take care
of it. That's far better than adding layer after layer of laquer over the
trash.
Rubbing out the finish is a method of adjusting the sheen of a finish. I
usually start with 0000 steel wool, followed by pumice (comes in different
grades) when shooting for a glossy finish.
You will need more coats than just two. If not enough coats you will cut
through your finish to the wood and you will need to start all over again.
Get this book:
http://www.amazon.com/gp/product/0762101911/103-7886838-0079022?v=glance&n=283155
--
Stoutman
http://home.triad.rr.com/brianmelissa/woodworking_frames.htm
"stoutman" <.@.> wrote in
news:[email protected]:
> You will need more coats than just two. If not enough coats you will
> cut through your finish to the wood and you will need to start all
> over again.
>
Also, lacquer does not need to be sanded between coats. The coat being
applied partially dissolves into the coat below. That process, as well as
the fast drying time, allow you to spray many coats fairly quickly. I
usually wait about 30 minutes between coats. I put the spray gun in a cool
place out of the sun while waiting and only clean it at the end of the
session.
-G
"Bugs" <[email protected]> wrote:
>Musical instruments can take 20 coats or more to achieve the high
>finish. Rubbing with pumice and rottenstone with mineral oil on a felt
>pad refines the surface after each coat. Put on as many coats as it
>takes to satisfy you.
>Bugs
Thanks for all the replys.
Sides turned out nice. Might have too shoot the top again, to rub it out.
Cabinet is Ash with quarter-sawn Cherry top and side inserts