Question for any users of the General Int 24" Drum sander, the website
claims the minimum thickness is 1/4", is that just as far as the table
will go? Is this surmountable with a sled of some sort? Comments?
Thanks
Steve Jensen
Abbotsford B.C.
[email protected] chopping out the mortise.
Surfing along at 19200 bps since 95.
BBS'ing since 1982 at 300 bps.
WW'ing since 1985
Nothing catchy to say, well maybe.....
WAKE UP - There are no GODs you fools!
Scorp wrote:
>
> Question for any users of the General Int 24" Drum sander, the website
> claims the minimum thickness is 1/4", is that just as far as the table
> will go? Is this surmountable with a sled of some sort? Comments?
Obviously you can always put something in there to contact the drum.
Whether it's the physical limit or the operational limit I don't know,
but don't think it really much matters.
What are you wanting to do? Knowing that might get some useful feedback
on whether it might be feasible or an alternate technique/route to go...