http://www.machinedesign.com/asp/viewSelectedArticle.asp?strArticleId=56442&strSite=MDSite&catId=2
Should be simple enough to duplicate. Might have to make a
prototype or three to get the holes spaced proper, but that'd be no
prob.
JOAT
A rolling stone gathers no moss...unless it's a hobby he does on the
weekends.
"J T" <[email protected]> wrote in message
>
http://www.machinedesign.com/asp/viewSelectedArticle.asp?strArticleId=56442&strSite=MDSite&catId=2
>
> Should be simple enough to duplicate. Might have to make a
> prototype or three to get the holes spaced proper, but that'd be no
> prob.
Wonder what they cost. Had a look on their website, but couldn't find any
mention of them.
Tue, Nov 29, 2005, 2:25pm [email protected] (Upscale) wonders:
Wonder what they cost. Had a look on their website, but couldn't find
any mention of them.
Just get a chunk of angle iron, cut it up, then some flat pieces,
bolts, and nuts. That, and a drill press, should be all you need.
Regular type hinges I would buy, something like this, I'd just make on
my own. If no heavy duty, could even use wood.
JOAT
A rolling stone gathers no moss...unless it's a hobby he does on the
weekends.