Would definitely keep cutter length and diameter under 1". Expect
adversity when the waste removed is much > 3/16 x 3/16.
Control is always an issue even for trimmers. One solution at the
http://www.patwarner.com/pc310_special.html link.
******************************************
> Anyone use this with round over bits and the like. Is it safe running at
> 30,000 rpm's with these type of bits in the unit? Do you get good control?
>
> Tim
I use mine more for small bits like roundovers than I do for laminate.
Preston
"TDUP" <[email protected]> wrote in message
news:[email protected]...
> Anyone use this with round over bits and the like. Is it safe running at
> 30,000 rpm's with these type of bits in the unit? Do you get good control?
>
> Tim
>
>