TABLE SAW JIG - To true up irregular stock

JOAT, do you have any idea why the guide piece is smaller than the work
piece? I would think you'd want the guide piece to extend beyond the
irregular piece, so it's fully supported from beginning to end.

Thanks,
Nathan

J T (in [email protected]) said:

| http://www.glen-l.com/wood-plywood/plate10h.html
|
| Or, joiting on the table saw.

And if you don't want nail holes in the jointed stock:

http://www.iedu.com/DeSoto/BoardSled.html will do the same job(s).

--
Morris Dovey
DeSoto Solar
DeSoto, Iowa USA
http://www.iedu.com/DeSoto