gittymoe wrote:
| I have recently stripped and restaind an oak table but when I put
| the Polyurethane on and sanded after the first application the
| sanding left my table cloudy. How can I fix this without starting
| over?
If it wasn't cloudy before the sanding, I think I'd try wiping
/rubbing on the very lightest possible coating of poly with a clean,
soft cloth - and plan on using a finer grit of paper the next time.
*Important* - I'd try it on scrap first!
--
Morris Dovey
DeSoto Solar
DeSoto, Iowa USA
http://www.iedu.com/DeSoto/
"dadiOH" <[email protected]> wrote in message
news:Dh8ki.568$mS3.507@trnddc03...
> gittymoe wrote:
>> I have recently stripped and restaind an oak table but when I put
>> the Polyurethane on and sanded after the first application the
>> sanding left my table cloudy. How can I fix this without starting
>> over?
>
> Cloudy? As in "all scratched up from the sanding"? Put on another
> coat of urethane.
Right -- the sanding is supposed to make it look cloudy; the second coat
then clears it up immediately.
gittymoe wrote:
> I have recently stripped and restaind an oak table but when I put
> the Polyurethane on and sanded after the first application the
> sanding left my table cloudy. How can I fix this without starting
> over?
Cloudy? As in "all scratched up from the sanding"? Put on another
coat of urethane.
--
dadiOH
____________________________
dadiOH's dandies v3.06...
...a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico