LC

"Larry C"

06/10/2009 12:54 PM

A sort of woodworking post

I have to install some 3/4 round on the outside of my house. I am using the
PVC stuff.

I am correct to use 3 inch stainless finish nails? If not what? I want to
use a nail gun. I have 100ft to do

Larry C


This topic has 3 replies

Sk

Swingman

in reply to "Larry C" on 06/10/2009 12:54 PM

06/10/2009 12:27 PM

Larry C wrote:
> I have to install some 3/4 round on the outside of my house. I am using
> the PVC stuff.
>
> I am correct to use 3 inch stainless finish nails? If not what? I want
> to use a nail gun. I have 100ft to do

2 1/4" stainless deck screws will work just fine ... you'll need the
1000 pack for $90 and a deck screw gun, but a guns a gun.

--
www.e-woodshop.net
Last update: 10/22/08
KarlC@ (the obvious)

Rr

RicodJour

in reply to "Larry C" on 06/10/2009 12:54 PM

06/10/2009 10:02 AM

On Oct 6, 12:54=A0pm, "Larry C" <[email protected]>
wrote:
> I have to install some 3/4 round on the outside of my house. =A0I am usin=
g the
> PVC stuff.
>
> I am correct to use 3 inch stainless finish nails? =A0If not what? =A0I w=
ant to
> use a nail gun. =A0I have 100ft to do

It'd be better to use two pieces of 3/8 round. Drive the nails first
- 16d common Monel ringshanks on 3" centers - and set them proud about
3/16", then route out recesses for the nail heads in both pieces of
3/8" to house the nail heads (make sure that you reverse the grain so
you don't get warping in the PVC). Then sandwich the nail heads in
between the two pieces of 3/8 round using PVC monoclonal cellular
adhesive, and use about 2000 headless pins to hold them in place while
the glue dries. Post some pictures next Spring when you're done.

R

jj

jo4hn

in reply to "Larry C" on 06/10/2009 12:54 PM

06/10/2009 11:43 AM

RicodJour wrote:
> On Oct 6, 12:54 pm, "Larry C" <[email protected]>
> wrote:
>> I have to install some 3/4 round on the outside of my house. I am using the
>> PVC stuff.
>>
>> I am correct to use 3 inch stainless finish nails? If not what? I want to
>> use a nail gun. I have 100ft to do
>
> It'd be better to use two pieces of 3/8 round. Drive the nails first
> - 16d common Monel ringshanks on 3" centers - and set them proud about
> 3/16", then route out recesses for the nail heads in both pieces of
> 3/8" to house the nail heads (make sure that you reverse the grain so
> you don't get warping in the PVC). Then sandwich the nail heads in
> between the two pieces of 3/8 round using PVC monoclonal cellular
> adhesive, and use about 2000 headless pins to hold them in place while
> the glue dries. Post some pictures next Spring when you're done.
>
> R
holy moley.!???


You’ve reached the end of replies