Help Wiring original Magswitch on Grizzly G-1012 BSaw

I am in need of some help wiring up the original magswitch on a
Grizzly G-1012 band saw.

The story is that when checking out this new-condition, second-hand
Saw it kept tripping the circuit. For some reason, at some point, I
figured the problem was in the switch. After trying the switch from
the dust collector, I discovered that the 240 rewire on the motor was
done wrong (hence the new condition). So, I eventually put the switch

back on the dust collector and need to get the original saw magswitch
back on so I can finally get some resawing done.

Oh, yes, the big mistake was not writing down the simple wiring
config and not getting the thing back on soon enough to remember.

I've talked to Gizz tech support and googled around but can not get
clear instruction on the easy wiring of this complex looking switch.

Could someone with that saw or another Grizz product with that
switch please open their switch and give me the ABCs of getting
rewired ?

This is the switch: http://tinyurl.com/gwlwl
This is the saw: http://tinyurl.com/zqbx3
This is not my wife nor my tool belt: http://tinyurl.com/khz4v

Thanks, Bart