PING: No-drip edge router bit request.

Robatoy wrote:
> I don't recall the OP, but here's the solution you're after.
> You probably have the gig completed by now, but here's a suggestion for
> any future challenges.

There's also this one, which leaves a rounded edge.

http://www.leevalley.com/wood/page.aspx?c=1&p=30109&cat=1,46168

Chris

In article <[email protected]>,
Chris Friesen <[email protected]> wrote:

> Robatoy wrote:
> > I don't recall the OP, but here's the solution you're after.
> > You probably have the gig completed by now, but here's a suggestion for
> > any future challenges.
>
> There's also this one, which leaves a rounded edge.
>
> http://www.leevalley.com/wood/page.aspx?c=1&p=30109&cat=1,46168
>
> Chris

*S*...yabbut... the challenge at hand was to continue the no-drip edge into the
inside corner of an L-shaped counter top...