Hi All,
I'm looking for plans to build benches and flower boxes for a deck. Here's
the catch, the deck is made from TimberTech which is a composite wood and
only comes in 5/4 x 6 or 3/4 x 10 or 12. I would like to make the benches
and flower boxes out of the same composite. The composite cuts and routers
well but if I do glue ups and have to plane or sand it, I'm going to lose
the wood grain effect.
So, I have to work with the boards as they are or trim them smaller. Any
ideas?
Thanks,
Joe
Edwin Pawlowski wrote:
> "Joe Ferraro" <[email protected]> wrote in message
>
>>So, I have to work with the boards as they are or trim them smaller. Any
>>ideas?
>>
>>Thanks,
>>Joe
>
>
> I'd work with the boards as they are or trim them smaller.
>
>
I'm with Ed.
On just about any project, I usually work with the boards as they are or
trim them smaller. Sometimes, I have to trim them more than once.
"Joe Ferraro" <[email protected]> wrote in message
>
> So, I have to work with the boards as they are or trim them smaller. Any
> ideas?
>
> Thanks,
> Joe
I'd work with the boards as they are or trim them smaller.