http://www.simplicityboats.com/papercut.html
Or, you could just lay a piece of wood on the paper, and tear it .
Or, you could fold it, and cut it with a knife, scissors, or whatever.
Just something more to clutter up the shop with, and to not be able to
find when you want it.
JOAT
Just pretend I'm not here. That's what I'm doing.
In article <[email protected]>, Lew
Hodgett <[email protected]> wrote:
> A hack saw blade does a decent job.
You beat me to it.
An old hacksaw blade can be attached to a piece of wood or bench edge
so that you slide the paper under it and pull up to tear...
--
"I'm a man, but I can change... If I have to... I guess." -- Red Green
In article <[email protected]>, Upscale
<[email protected]> wrote:
> I keep an old pair of heavy duty scissors on hand for cutting
I bought a couple of sets of these
<http://www.leevalley.com/garden/page.aspx?c=1&p=10215&cat=2,50560> a
while back. One for the kitchen, one for the shop.
djb
--
"Wherever there is a jackboot stomping on a human face there will be a
well-heeled Western liberal to explain that the face does, after all, enjoy
free health care and 100 percent literacy." -- John Derbyshire
On Sun, 20 Nov 2005 13:16:59 -0600, Dave Balderstone
<dave@N_O_T_T_H_I_S.balderstone.ca> wrote:
>In article <[email protected]>, Upscale
><[email protected]> wrote:
>
>> I keep an old pair of heavy duty scissors on hand for cutting
I loosely screwed a hacksaw blade to an MDF scrap. The back side of
the blade tears the paper nicely. The MDF has commonly used sizes
marked off with a Sharpie.
Barry
"Dave Balderstone" <dave@N_O_T_T_H_I_S.balderstone.ca> wrote in message
>
> An old hacksaw blade can be attached to a piece of wood or bench edge
> so that you slide the paper under it and pull up to tear...
I keep an old pair of heavy duty scissors on hand for cutting. Cuts
sandpaper, cardboard, thin sheet metal, rubber and most anything else that's
flexible. Not as fashionable as a hacksaw blade, but definitely more
workable.
On Fri, 18 Nov 2005 03:47:42 -0500, J T wrote:
> http://www.simplicityboats.com/papercut.html
>
> Or, you could just lay a piece of wood on the paper, and tear it .
> Or, you could fold it, and cut it with a knife, scissors, or whatever.
> Just something more to clutter up the shop with, and to not be able to
> find when you want it.
>
>
>
> JOAT
> Just pretend I'm not here. That's what I'm doing.
I've been using one similar to this for a long time. I have a ledge to act
as a stop to cut the sheets in thirds. It's hanging from the wall and is
used in that position so it isn't underfoot and it can't get lost. I use
it 3-4 times a day when I'm turning bowls & such.
Bill