"Jerry" <[email protected]> wrote in message
news:[email protected]...
>I have a Delta 34-444 contractors saw. Can one purchase cast iron
> extensions to replace the stamped extensions? Has anyone done this?
>
>
I bought the cast iron wing as well for my 444. About $90. I like it.
(Sorry about the email - learning new software)
Steve LaBroad
On 9 Feb 2006 11:22:44 -0800, "Jerry" <[email protected]> wrote:
>I have a Delta 34-444 contractors saw. Can one purchase cast iron
>extensions to replace the stamped extensions? Has anyone done this?
Check deltamachinery.com to find the part number and your local
dealer.
Mike O.
Delta standardized on a 10" cast iron wing and it fits everything from the
unisaw to the contractor to the shaper at about $90. Any Delta vendor
should be able to get you 1, or 2. The higher end contractors only come
with a left CI wing and a table board on the right side.
"Mike O." <[email protected]> wrote in message
news:[email protected]...
> On 9 Feb 2006 11:22:44 -0800, "Jerry" <[email protected]> wrote:
>
> >I have a Delta 34-444 contractors saw. Can one purchase cast iron
> >extensions to replace the stamped extensions? Has anyone done this?
>
> Check deltamachinery.com to find the part number and your local
> dealer.
>
> Mike O.
In article <[email protected]>,
"Jerry" <[email protected]> wrote:
> I have a Delta 34-444 contractors saw. Can one purchase cast iron
> extensions to replace the stamped extensions? Has anyone done this?
Jerry
I did this a few years ago for my 444 saw. I got it through Amazon.
Sorry, can't remember how much it cost--something around $80.00 comes to
mind.
dp
--
[email protected]
www.brndogwoodworks.com