On 10/26/2017 4:51 PM, Electric Comet wrote:
> On Thu, 26 Oct 2017 16:37:14 -0400
> Ed Pawlowski <[email protected]> wrote:
>
>>
>> Yes, for both.
>
> went with the metal as it seems to me the mud will adhere better to
> metal than the plastic
>
>
>
>
>
>
>
>
>
I try to never use mud in my woodworking. Even my _worst_ joints are tight
enough that it is not needed.
On Wed, 1 Nov 2017 18:33:04 -0700, Electric Comet
<[email protected]> wrote:
>On Mon, 30 Oct 2017 12:40:58 -0700
>Electric Comet <[email protected]> wrote:
>
>> one possible con against the metal bead is that it can rust if in a
>> moisture prone environment
>>
>
>looking more closely at this corner bead i am starting to think it is
>galvanized
>
>guessing that it is hot dipped galvanized
>
>i do recall seeing rusted corner bead but it may have been an old
>installation
>
>
>
>
>
>
>
>
I've seen a fair bit of rusted corner bead - when in a damp area with
no paint. The stuff is lightly galvanized - there are also blastic
corner beads that won't rust - - -
On Thu, 26 Oct 2017 16:37:14 -0400
Ed Pawlowski <[email protected]> wrote:
>
> Yes, for both.
went with the metal as it seems to me the mud will adhere better to
metal than the plastic
On Wed, 25 Oct 2017 11:23:12 -0700
Electric Comet <[email protected]> wrote:
> i see plastic ones and there are metal ones
>
> any pros or cons for either type
one possible con against the metal bead is that it can rust if in a
moisture prone environment
hopefully paint would prevent that and probably not a factor here
but one possible downside for metal
On Mon, 30 Oct 2017 12:40:58 -0700
Electric Comet <[email protected]> wrote:
> one possible con against the metal bead is that it can rust if in a
> moisture prone environment
>
looking more closely at this corner bead i am starting to think it is
galvanized
guessing that it is hot dipped galvanized
i do recall seeing rusted corner bead but it may have been an old
installation