Hi all,
Anyone got any idea as to what to pay for a couple of items?
I have a shot at a Grizzly 8" Jointer G1018 which was purchased new in 92 by
the current owner (a woodworking shop). They want $400 for it. There's no
rust, and all parts seem to be intact. Comes with a manual. Current prices
on a new G1018 is around $750 with shipping, so I tend to think $400 may be
a little steep on a 12 year old machine at this point, but don't know what
the going price may be on these.
Also, they have a Hegner HB 200 lathe for which they want $700. It does not
have electrionic control so speed is changed via pulleys. Don't know how
old it is.
What are specific things I should take into consideration on these machines
before I make a possible offer?
Thanks in advance,
Chris
On Sun, 19 Oct 2003 18:29:51 -0500, "Cromwell" <[email protected]>
Crawled out of the shop and said. . .:
>Hi all,
>
>Anyone got any idea as to what to pay for a couple of items?
>
>I have a shot at a Grizzly 8" Jointer G1018 which was purchased new in 92 by
>the current owner (a woodworking shop). They want $400 for it. There's no
>rust, and all parts seem to be intact. Comes with a manual. Current prices
>on a new G1018 is around $750 with shipping, so I tend to think $400 may be
>a little steep on a 12 year old machine at this point, but don't know what
>the going price may be on these.
>
don't know about the lathe, but the jointer is a steal if its decent
shape. if you don't want it, lemme know where ya are and i'll go buy
it! heheh
Traves
On Sun, 19 Oct 2003 18:29:51 -0500, "Cromwell" <[email protected]>
wrote:
>Hi all,
>
>Anyone got any idea as to what to pay for a couple of items?
>
>I have a shot at a Grizzly 8" Jointer G1018 which was purchased new in 92 by
>the current owner (a woodworking shop). They want $400 for it. There's no
>rust, and all parts seem to be intact. Comes with a manual. Current prices
>on a new G1018 is around $750 with shipping, so I tend to think $400 may be
>a little steep on a 12 year old machine at this point, but don't know what
>the going price may be on these.
>
>Also, they have a Hegner HB 200 lathe for which they want $700. It does not
>have electrionic control so speed is changed via pulleys. Don't know how
>old it is.
>
>What are specific things I should take into consideration on these machines
>before I make a possible offer?
>
>Thanks in advance,
>
>Chris
>
Chris:
In a general sense a used machine is worth about sixty percent of its
current cost if it is in very good condition and less than about five
years old. The cost basis should include the cost of whatever
electricals are on the machine.
On a twelve year old Grizzly I'd only give about forty to forty five
percent of current cost and would take a good straight edge with me to
determine that the tables haven't humped and that the ways have not
gotten sloppy to the point where the tables can not be made planar.
You might also check the fence to make sure it is not humped.
Take a drill rod with you to check the runout on the Hegner and try to
find out the age of the machine.
Regards, Tom
Thomas J. Watson-Cabinetmaker
Gulph Mills, Pennsylvania
http://users.snip.net/~tjwatson