On Sat, 25 Feb 2006 15:51:53 GMT, bdeditch <[email protected]>
wrote:
>Has anyone here every used these kits for there router Bits, if so how
>were they?
They work very well as long as you're using a good quality router with
low run-out. The QuickRout is well balanced, but its mass will magnify
excessive run-out that may exist in the shaft of the router.
Here's the company that created the QuickRout:
www.lhrtech.com
While you're there, take a look at the CarveWright machine - the
QuickRout is an integral part of that machine (it's a low cost CNC
machine).
cdo