ROUTER DADO JIG

On Mar 2, 3:58 am, Bob Martin <[email protected]> wrote:
> in 1398460 20080301 125536 "Bonehenge (B A R R Y)" <[email protected]> wrote:
>
> >On Sat, 1 Mar 2008 01:09:53 -0500, [email protected] (J T)
> >wrote:
>
> >>http://www.newwoodworker.com/rtrdadojig.html
>
> >Ah...
>
> >The classic straight edge that also works for circular saws.
>
> I prefer to run between two straight edges when cutting a dado

Well you can make two of those, and use a scrap
of the same thickness as the tenon fitting into the
dado to establish the separation between them.

Cut with a bit that is at least one half and
not more than smaller than the desired width
of the dado, Route up one side and down the
other--no climbing cuts.

--

FF

On Sat, 1 Mar 2008 01:09:53 -0500, [email protected] (J T)
wrote:

>http://www.newwoodworker.com/rtrdadojig.html

Ah...

The classic straight edge that also works for circular saws.

in 1398460 20080301 125536 "Bonehenge (B A R R Y)" <[email protected]> wrote:
>On Sat, 1 Mar 2008 01:09:53 -0500, [email protected] (J T)
>wrote:
>
>>http://www.newwoodworker.com/rtrdadojig.html
>
>Ah...
>
>The classic straight edge that also works for circular saws.

I prefer to run between two straight edges when cutting a dado

On Mar 1, 1:09 am, [email protected] (J T) wrote:
> ...
> JOAT
> 10 Out Of 10 Terrorists Prefer Hillary For President - Bumper Sticker
>
> I do not have a problem with a woman president - except for Hillary.

That's OK. I don;t have a problem with old farts,
except for those who put things like that in their .sig.

--

FF