I had br111 brazilian cherry installed last week but have some
questions. It was glued down to a concrete floor. However, there are
a few hollow sounding spots and a few spots where the floor actually
"gives" a bit when you walk over it. What can I do and how can I hold
the installer responsible. Is this to be expected with this type of
installation? How can this be fixed?
Edwin Pawlowski wrote:
> "Clint" <[email protected]> wrote in message
> news:UhC_e.314847$on1.219648@clgrps13...
> > Well, my first thought was put down a piece of tape, drill through the
> > tape (and floor) with a small drill bit, and inject some epoxy into the
> > cavity. I have NO idea if this is a good idea or not, but it's my
> > inclination.
>
> That was my second though. My first is to just leave it alone. The
> concrete floor is probably not perfect and the wood sprung before hte glue
> could set. I have a few spots like that and nothing has come of them after
> a few years.
Depending on the type of glue that was used you might be able to
put something heavy on the springy spot for a week or so and it
might stick thereafter. I had a threshold that walked around
for a couple of months befor it finally stuck. It was slightly
cupped, concave down, until it stuck. My guess is that was
due to moisture in the mastic and when the mastic dried the
threshold straightend out and stuck.
Latex mastics, under flooring can stay a little sticky for a
long time.
--
FF
Well, my first thought was put down a piece of tape, drill through the tape
(and floor) with a small drill bit, and inject some epoxy into the cavity.
I have NO idea if this is a good idea or not, but it's my inclination.
--
Clint
<[email protected]> wrote in message
news:[email protected]...
>I had br111 brazilian cherry installed last week but have some
> questions. It was glued down to a concrete floor. However, there are
> a few hollow sounding spots and a few spots where the floor actually
> "gives" a bit when you walk over it. What can I do and how can I hold
> the installer responsible. Is this to be expected with this type of
> installation? How can this be fixed?
>
"Clint" <[email protected]> wrote in message
news:UhC_e.314847$on1.219648@clgrps13...
> Well, my first thought was put down a piece of tape, drill through the
> tape (and floor) with a small drill bit, and inject some epoxy into the
> cavity. I have NO idea if this is a good idea or not, but it's my
> inclination.
That was my second though. My first is to just leave it alone. The
concrete floor is probably not perfect and the wood sprung before hte glue
could set. I have a few spots like that and nothing has come of them after
a few years.