miter gauge tip

Good thinking. You might also check the squareness of your mitre gauge.
Tom
[email protected] wrote:
> This might be something that many of you already do, but I was having
> trouble keeping
> my workpiece from sliding back and forth a small amount while cutting a
> miter on a tablesaw,
> resulting in a not-so-straight cut. I found that putting a piece of
> adhesive backed sandpaper
> on the face of the miter gauge to grip the wood really helped.

tom wrote:
> Good thinking. You might also check the squareness of your mitre gauge.


Where it really helps is when you're cutting an angle other than 90
degrees,
because that's when the piece tends to slide the most. Takes the
whiteness
out of the knuckles, its no good to be tense around a table saw.

On 13 Jun 2006 18:28:25 -0700, "[email protected]"
<[email protected]> wrote:

>This might be something that many of you already do, but I was having
>trouble keeping
>my workpiece from sliding back and forth a small amount while cutting a
>miter on a tablesaw,
>resulting in a not-so-straight cut. I found that putting a piece of
>adhesive backed sandpaper
>on the face of the miter gauge to grip the wood really helped.

I've seen fences offered for some miter gages that have some kind of
non slip material on them. I've never tried them though.
It's been my observation that if I tend to have some slipping, against
the gage, it's usually time to put on a sharp blade.

Mike O.