Well crap, crap, and triple crap. I was routing edge splines in a Greene
and Greene breadboard top with a slot cutting bit in a PC 690 with a fixed
base. Een though I checked and checked to ensure the screw on the base was
tight the router slipped down once I started cutting the slot. Fortunately
it didn't go through the entire top. I need to patch the slot an try again.
Do the older style fixed base with a thumb screw have a tendency to work
lose and slip once routing starts? I had tightened it down as much as a
could without a mechnical aid.
Are the newer fixed bases better?
"xxxx" wrote:
>>Do the older style fixed base with a thumb screw have a tendency to
>>work
>>lose and slip once routing starts? I had tightened it down as much
>>as a
>>could without a mechnical aid.
>
>>Are the newer fixed bases better?
-------------------------------------------------------
"tdacon" wrote:
>
> Yes, and yes. After a few mishaps like yours, one of which involved
> the router motor dropping completely down out of a bench-top router
> table while running, I got in the habit of tightening the thumb
> screw with a pair of pliers before I hit the switch.
----------------------------------------------------
Ditto except mine was a Cresant wrench AKA: Knuckle Buster.
Lew
---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com
On 6/25/2014 9:10 AM, xxxx wrote:
> Well crap, crap, and triple crap. I was routing edge splines in a Greene
> and Greene breadboard top with a slot cutting bit in a PC 690 with a fixed
> base. Een though I checked and checked to ensure the screw on the base was
> tight the router slipped down once I started cutting the slot. Fortunately
> it didn't go through the entire top. I need to patch the slot an try again.
>
> Do the older style fixed base with a thumb screw have a tendency to work
> lose and slip once routing starts? I had tightened it down as much as a
> could without a mechnical aid.
>
> Are the newer fixed bases better?
>
You might try getting a can of that rubber coating stuff and very very
lightly mist the motor housing. Having to tighten the screw beyond what
one would expect puts undue stress on the whole mechanism. Better to
try to decrease the slipperiness.
Most routers these days that use the method of squeezing the base have
adopted a flip lever to tighten the base along with in many instances an
indexing pen for up and down adjustment. ie. the Bosch 1617 fixed base
router. The locking flip lever simply decreases the slop after adjustment.
"xxxx" wrote in message
news:[email protected]...
>Do the older style fixed base with a thumb screw have a tendency to work
>lose and slip once routing starts? I had tightened it down as much as a
>could without a mechnical aid.
>Are the newer fixed bases better?
Yes, and yes. After a few mishaps like yours, one of which involved the
router motor dropping completely down out of a bench-top router table while
running, I got in the habit of tightening the thumb screw with a pair of
pliers before I hit the switch.
I replaced the fixed base with one of the newer ones with the cam lever
tightening mechanism, and I haven't had a problem since.
Tom