Hi, another weird question...
...well I was wondering how important is misalignment in a table saw. Lets
suppose the saw axis is not perfectly perpendicular to the ripping fence. If
you guide with the fence anyway you will get a cut perfectly parallel to the
fence. The saw misalignment will only cause that the cut will be wider than
the saw width. Even it could be useful for grooving, just you can adjust the
groove width...
Am I right?
Thanks in advance
--
Faustino Dina
--------------------------------------------------------
If my email address starts with two 'f'
drop the first 'f' when mailing me.
Faustino Dina wrote:
> Hi, another weird question...
>
> ...well I was wondering how important is misalignment in a table saw. Lets
> suppose the saw axis is not perfectly perpendicular to the ripping fence. If
> you guide with the fence anyway you will get a cut perfectly parallel to the
> fence. The saw misalignment will only cause that the cut will be wider than
> the saw width. Even it could be useful for grooving, just you can adjust the
> groove width...
> Am I right?
Although it is strongly recommended to have the blade parallel to the fence,
technically you are correct. In fact, by skewing the fence it is possible to
cut coves and make raised panels using the table saw. Here's a link to an
article showing how to make a raised panel.
http://home.austin.rr.com/sawduster/Raisedpanels/Raisedpanels.HTM
--
Jack Novak
Buffalo, NY - USA
(Remove "SPAM" from email address to reply)
Don Vest wrote:
> WRONG!
>
> Alignment is VERY important.
>
> Burning of the wood, blade warp or distortion, binding etc. are all caused
> by misalignment. Get it as close as possible.
Don't forget kickback, kickback, kickback. A grossly misaligned blade is a
very dangerous thing. DAMHIKT.
--
Michael McIntyre ---- Silvan <[email protected]>
Linux fanatic, and certified Geek; registered Linux user #243621
http://www.geocities.com/Paris/Rue/5407/
WRONG!
Alignment is VERY important.
Burning of the wood, blade warp or distortion, binding etc. are all caused
by misalignment. Get it as close as possible.
"Faustino Dina" <[email protected]> wrote in message
news:[email protected]...
> Hi, another weird question...
>
> ...well I was wondering how important is misalignment in a table saw. Lets
> suppose the saw axis is not perfectly perpendicular to the ripping fence.
If
> you guide with the fence anyway you will get a cut perfectly parallel to
the
> fence. The saw misalignment will only cause that the cut will be wider
than
> the saw width. Even it could be useful for grooving, just you can adjust
the
> groove width...
> Am I right?
>
> Thanks in advance
>
> --
> Faustino Dina
> --------------------------------------------------------
> If my email address starts with two 'f'
> drop the first 'f' when mailing me.
>
>