On May 7, 2:26 pm, GrayFox <[email protected]> wrote:
> Norm was making a table with inlays in the top. He used some stuff to
> keep the stain he was applying from bleeding into the inlays.
>
> What was the stuff?
shellac.
D'ohBoy
On May 7, 2:26 pm, GrayFox <[email protected]> wrote:
> Norm was making a table with inlays in the top. He used some stuff to
> keep the stain he was applying from bleeding into the inlays.
>
> What was the stuff?
Shellac blonde to be exact. I think he said that it was a 1/2lb. cut,
but I'd have to check that part. bc
On May 7, 2:26 pm, GrayFox <[email protected]> wrote:
> Norm was making a table with inlays in the top. He used some stuff to
> keep the stain he was applying from bleeding into the inlays.
>
> What was the stuff?
My question is, why not stain first and then inlay? I know you HAVE to
stain it because after all, it's Norm. The only other option is paint.
But why not stain it first and then do the inlay so you don't have to
worry about bleeding? Is it because the router sliding over the
stained wood might scratch it?
Because if you stain first you can't sand the inlay flat after you
install it without marring the stain. That is unless you're alot
better at inlay than I am ;) bc
On May 7, 3:41 pm, "[email protected]" <[email protected]> wrote:
> On May 7, 2:26 pm, GrayFox <[email protected]> wrote:
>
> > Norm was making a table with inlays in the top. He used some stuff to
> > keep the stain he was applying from bleeding into the inlays.
>
> > What was the stuff?
>
> My question is, why not stain first and then inlay? I know you HAVE to
> stain it because after all, it's Norm. The only other option is paint.
> But why not stain it first and then do the inlay so you don't have to
> worry about bleeding? Is it because the router sliding over the
> stained wood might scratch it?
Most likley the stain is a NGR type and has a solvent base that turns the
tape adhesive into a sticky mess. Not only will the stain penetrate the tape
but the residue will interfere with the finish coats....mjh
"bent" <[email protected]> wrote in message
news:[email protected]...
> blue painters masking tape
>
> What was the stuff?
>
>
> ----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet
> News==----
> http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+
> Newsgroups
> ----= East and West-Coast Server Farms - Total Privacy via Encryption
> =----
"mike hide" <[email protected]> wrote in message
news:[email protected]...
> Most likley the stain is a NGR type and has a solvent base that turns the
> tape adhesive into a sticky mess. Not only will the stain penetrate the
> tape but the residue will interfere with the finish coats....mjh
IIRC there was no tape after he finish sanded and prepped for the stain. He
put the inlay in tape side up, removed the tape after the glue dried, then
smoothed the surface before applying the shellac.