"Paul Franklin" <[email protected]> wrote in message
news:[email protected]...
>
> Alternatively, get a piece of pipe with right OD and sharpen the end
> of it with a file to make a hole punch (bevel the inside, not the
> outside) Put the brass on a piece of scrap, position the pipe, and
> give the pipe a good whack.
>
> HTH,
>
> Paul Franklin
>
This method gets my vote.
You can also check out Harbor Freight. They usually have cheap hole punch
sets that are just like this but already sharp and heat treated. They might
be named gasket punches.
If you want to make your own chucking it up in a lathe and ro0tating it
while using a dremmel tool with a stone would make short work of the task.
--
Roger Shoaf
About the time I had mastered getting the toothpaste back in the tube, then
they come up with this striped stuff.
"Jack" <[email protected]> wrote in message
news:[email protected]...
>I have some very thin brass flashing and want to cut a hole in it. To thin
>for a whole saw. Making hole protectors for bird houses
>
You could always draw the circle you need on the brass and cut it out with a
scroll saw.
muzzleloader
On Wed, 09 May 2007 01:48:04 GMT, "Jack" <[email protected]> wrote:
>I have some very thin brass flashing and want to cut a hole in it. To thin
>for a whole saw. Making hole protectors for bird houses
>
Sandwich it between two pieces of 1/4 ply (or almost any two pieces of
wood), clamp tight and drill with your favorite bit.
Alternatively, get a piece of pipe with right OD and sharpen the end
of it with a file to make a hole punch (bevel the inside, not the
outside) Put the brass on a piece of scrap, position the pipe, and
give the pipe a good whack.
HTH,
Paul Franklin