jerry,
thanks for the reply. i'll keep my eyes open and try a Delta
extension if one pops up.
andy b.
On Fri, 03 Oct 2003 13:48:59 GMT, [email protected] (Jerry
McCaffrey) wrote:
>[email protected] (hamrdog) wrote in <3f7cee4f.92011283
>@news.ptdprolog.net>:
>
>>any idea what current brand of saw table extension would fit on an old
>>Atlas 3060 10" saw? i am looking for an extension for the left side
>>of the table. i don't know if table extensions are some standard
>>size, and i don't have any other table saws laying around to try a
>>piece.
>>
>>andy b.
>>
>
>I found an old Delta cast wing and mounted it w/o problem. It is about 2
>inches too short front to back. It serves as work piece support, but I've
>never shimmed it out to extend the fence more left. The real issue is
>getting it shimmed and true for the front/back locking fence to engage
>properly. Not that hard just tedious.
>
>Jerry
[email protected] (hamrdog) wrote in <3f7cee4f.92011283
@news.ptdprolog.net>:
>any idea what current brand of saw table extension would fit on an old
>Atlas 3060 10" saw? i am looking for an extension for the left side
>of the table. i don't know if table extensions are some standard
>size, and i don't have any other table saws laying around to try a
>piece.
>
>andy b.
>
I found an old Delta cast wing and mounted it w/o problem. It is about 2
inches too short front to back. It serves as work piece support, but I've
never shimmed it out to extend the fence more left. The real issue is
getting it shimmed and true for the front/back locking fence to engage
properly. Not that hard just tedious.
Jerry
hamrdog wrote:
> any idea what current brand of saw table extension would fit on an old
> Atlas 3060 10" saw? i am looking for an extension for the left side
> of the table. i don't know if table extensions are some standard
> size, and i don't have any other table saws laying around to try a
> piece.
My first choice would be something like this... <g>
http://www.grizzly.com/products/item.cfm?itemnumber=G4227
http://www.mulecab.com/products.asp?mnu_Products=4
-- Mark
In article <[email protected]>,
"Mark Jerde" <[email protected]> wrote:
> hamrdog wrote:
> > any idea what current brand of saw table extension would fit on an old
> > Atlas 3060 10" saw? i am looking for an extension for the left side
> > of the table. i don't know if table extensions are some standard
> > size, and i don't have any other table saws laying around to try a
> > piece.
>
> My first choice would be something like this... <g>
>
> http://www.grizzly.com/products/item.cfm?itemnumber=G4227
Have you looked at the specs on this? Here's some extracts from the
Data Sheet:
Typical Cross Cut Capacity .............................1"
Total Travel ...........................................# 4 Morse Taper
Weight (Net) ...........................................390 lbs.
Weight (Shipping).......................................467 lbs.
You gotta wonder how well they proofread this stuff :-)