butcher block table question

Traditionally the blocks were made from birch and bolted together in a
frame. As end grain was used the small gaps were filled with the
meshing fibres. Having worked with birch i can see why it was the wood
of choice. i would just use a belt sander after assembly.

Chris,

If you have a friend with a planner or jointer you can run the
boards through them before you glue them up.

Rob

Chris Nail wrote:
> I am building a butcher block table and constructing the top by
gluing
> together 15 pieces of 2" hard maple. As expected the pieces are not
> lining up just right. I was wondering if anyone can lend advice as
to
> the best method of smoothing out the pieces. I thought about using a
> belt sander to "grind" them smooth. Since end grain is showing,
would
> this be ok? (I don't have any experience with a belt sander so
forgive
> my ignorance.) If the belt sander method would work, what path
should
> I take to accomplish my goal? Should I work parallel to the lines or
> perpendicular?
>
> Thanks in advance for your help....
>
> Chris

I would take the whole thing to a local sawmil or cabinet shop or ? and have
them run it through the large belt sander. You'll pay a fee for it but it
should be reasonable. You'll accomplish what you want in a few minutes.

--
Jeff P.

A truck carrying copies of Roget's Thesaurus over-turned on the
highway. The local newspaper reported that the onlookers were
"stunned, overwhelmed, astonished, bewildered, and dumfounded."

Check out my woodshop at: www.sawdustcentral.com


"Chris Nail" <[email protected]> wrote in message
news:[email protected]...
> I am building a butcher block table and constructing the top by gluing
> together 15 pieces of 2" hard maple. As expected the pieces are not
> lining up just right. I was wondering if anyone can lend advice as to
> the best method of smoothing out the pieces. I thought about using a
> belt sander to "grind" them smooth. Since end grain is showing, would
> this be ok? (I don't have any experience with a belt sander so forgive
> my ignorance.) If the belt sander method would work, what path should
> I take to accomplish my goal? Should I work parallel to the lines or
> perpendicular?
>
> Thanks in advance for your help....
>
> Chris
>