[email protected] wrote:
> When I Google this topic I get a variety of sharpening tips most using
> "diamond paddles" which I've found at Rockler and other sites for a
> reasonable price ($14.99 for 3 grits). I'm wondering if you can
> really sharpen carbide bits with these. Has anybody tried? If so,
> how'd you do?
> Thanks.
Carbide is hard enough you will spend a long time getting the bits truely
sharp. You can touch them up if they aren't very dull but if they are
they really need power equipment to sharpen.
On Fri, 11 Jan 2008 16:31:12 -0500, [email protected] wrote:
>When I Google this topic I get a variety of sharpening tips most using
>"diamond paddles" which I've found at Rockler and other sites for a
>reasonable price ($14.99 for 3 grits). I'm wondering if you can
>really sharpen carbide bits with these. Has anybody tried? If so,
>how'd you do?
I tried cleaning the flat with diamond paddles on a basic bit and
didn't see a real difference.
I get my better (+$50) bits professionally sharpened for ~ $10. My
local Woodcraft can send them out, or I can get them to CT Saw or
Ballew Tools.
<[email protected]> wrote in message
news:[email protected]...
> When I Google this topic I get a variety of sharpening tips most using
> "diamond paddles" which I've found at Rockler and other sites for a
> reasonable price ($14.99 for 3 grits). I'm wondering if you can
> really sharpen carbide bits with these. Has anybody tried? If so,
> how'd you do?
> Thanks.
If the cost of sending them out and getting them back is less than a new
bit, do that. Otherwise, just buy a new bit. I've never had any luck
(patience?) to succeed to any measurable degree with diamond paddles.
jc