I saw one on display at a Rocklers.
Now, mind you, display models have a way of being set-up piss poorly,
so my comment may not TRULY be indicative of the real quality of the
saw.
Caveats aside, I have to say I was underwhelmed. The blade raising and
tilting mechanisms had an incredible amount of binding in them, an
issue that was compounded by cheap plastic handwheels.
The tabletops had a mirror finish on them, however...which is better
than you can say about the Unisaws. Didn't have my 36" Starrett on
hand, so didn't check for flatness. :-)
Other than getting some fingerprints on it, that's my only experience
with the saw. I can't say how it cuts or how smoothly it runs.
"John Smith" <[email protected]> wrote in message
news:[email protected]...
> Anyone have an opinion about this saw?
>
> Thanks,
> Mark
>
You've seen one Chinese saw, you've seen them all.
Jim
"John Smith" <[email protected]> wrote in message
news:[email protected]...
> Well.....did you have a better suggestion??
You need to look at all of the hybrid saws. Dewalt was the first. Jet and
Grizzly make good ones (well, I should say sell) as well.
Isn't the Delta a little underpowered at 1 3/4 hp?
They all look like they were made in the same factory.
Jim
>
>
> Mark
> "Jim" <[email protected]> wrote in message
> news:BVQdf.16505$q%[email protected]...
>>
>> "John Smith" <[email protected]> wrote in message
>> news:[email protected]...
>>> Anyone have an opinion about this saw?
>>>
>>> Thanks,
>>> Mark
>>>
>> You've seen one Chinese saw, you've seen them all.
>> Jim
>>
>
>
Well.....did you have a better suggestion??
Mark
"Jim" <[email protected]> wrote in message
news:BVQdf.16505$q%[email protected]...
>
> "John Smith" <[email protected]> wrote in message
> news:[email protected]...
>> Anyone have an opinion about this saw?
>>
>> Thanks,
>> Mark
>>
> You've seen one Chinese saw, you've seen them all.
> Jim
>
"Jim" <[email protected]> wrote in message
news:BVQdf.16505$q%[email protected]...
>
> "John Smith" <[email protected]> wrote in message
> news:[email protected]...
>> Anyone have an opinion about this saw?
>>
>> Thanks,
>> Mark
>>
> You've seen one Chinese saw, you've seen them all.
> Jim
What an ignorant comment.