rc

"ron"

04/09/2007 9:43 PM

uneven jointer

Haven't been out to my shop for a while. While shaking off the rust
(woodworking is definitely a perishable skill), I noticed something odd
about my jointer.
After making a couple passes on the edge of an oak board, the leading
edge has more wood removed than the trailing edge.
I checked the outfeed table and it is the same height as the knives.
I am sure, as usual, I am overlooking the obvious, but I would
appreciate any suggestions.


This topic has 3 replies

TT

"Toller"

in reply to "ron" on 04/09/2007 9:43 PM

05/09/2007 3:07 AM


"ron" <capncapn2000@yahoo.com> wrote in message
news:hPudnaHPRe_UikPbnZ2dnUVZ_hisnZ2d@trueband.net...
> Haven't been out to my shop for a while. While shaking off the rust
> (woodworking is definitely a perishable skill), I noticed something odd
> about my jointer.
> After making a couple passes on the edge of an oak board, the leading
> edge has more wood removed than the trailing edge.
> I checked the outfeed table and it is the same height as the knives.
> I am sure, as usual, I am overlooking the obvious, but I would
> appreciate any suggestions.
If it is flat, it is working properly. It is a jointer, not a thickness
planer.

dn

dpb

in reply to "ron" on 04/09/2007 9:43 PM

05/09/2007 8:32 AM

Toller wrote:
> "ron" <capncapn2000@yahoo.com> wrote in message
> news:hPudnaHPRe_UikPbnZ2dnUVZ_hisnZ2d@trueband.net...
>> Haven't been out to my shop for a while. While shaking off the rust
>> (woodworking is definitely a perishable skill), I noticed something odd
>> about my jointer.
>> After making a couple passes on the edge of an oak board, the leading
>> edge has more wood removed than the trailing edge.
>> I checked the outfeed table and it is the same height as the knives.
>> I am sure, as usual, I am overlooking the obvious, but I would
>> appreciate any suggestions.
> If it is flat, it is working properly. It is a jointer, not a thickness
> planer.

A well-tuned jointer will remove an even amount along the whole length
starting with a straight piece.

Several things could be going on here, not enough to tell precisely what
the problem is or if there is a problem necessarily...

If the piece wasn't straight to start with, then yes, it's possible the
variation was what was needed to make it straight.

If the piece was straight (OP was simply cleaning up a rip on the
tablesaw or similar), then the knives may not be quite as level w/ the
table as thinks or there may be some droop in the outfeed table. On of
the most common problems giving rise to the symptoms is nonuniform feed
pressure when passing the work over the cutterhead. Dull knives can
contribute making it harder to get a clean cut.

Need some more detail of what/how/how much/conditions to really tell
what might be going on...

--

Ll

Leuf

in reply to "ron" on 04/09/2007 9:43 PM

05/09/2007 10:35 AM

On Wed, 05 Sep 2007 08:32:56 -0500, dpb <none@non.net> wrote:

>A well-tuned jointer will remove an even amount along the whole length
>starting with a straight piece.

Oh dear. Here we go again....


-Leuf


You’ve reached the end of replies