I have a long bolt. A round head bolt that I have turned the square
round. (almost round - tapering it a bit to fit tighter.)
I place the bolt in the spindle from the far end and it sticks out maybe
4". I use a rubber mallet and give it a whack while I hold the
spur in a rag. The spur pops out and I withdraw the bolt.
Martin
On 4/13/2016 10:19 AM, Electric Comet wrote:
> On Tue, 116 Apr 2016 34:44:01 +00000
> Peter Queens <1234abcdef4325344564567566856856_53453453453456346@@example.com> wrote:
>
>> remove the headstock spindle (spur Center) rockwell in this lathe
>
> what did you try and what happened
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
On Sat, 16 Apr 2016 23:01:32 -0500
Martin Eastburn <[email protected]> wrote:
> I place the bolt in the spindle from the far end and it sticks out
> maybe 4". I use a rubber mallet and give it a whack while I hold the
> spur in a rag. The spur pops out and I withdraw the bolt.
i do the same but this other lathe owner has a problem with theirs
as apparently it is not an mt but instead it screws on
but they never say what they tried so hard to offer any assistance