Anyone in this group have experience using this Jet Planer/Molder for
Molding Widths over 4"?
I just ordered some new BaseBoard knives from moldingknives.com. The knife I
wanted was 4 3/4". I was told by the salesman that I would have to buy 2
different knives instead of 1 wraparound knife, stating that the JPM13 did
not have enough power to produce the molding in one pass. Now I will have
to run my stock through twice, changing knives in between. I am running 4
7/8 x 3/4" Red Oak through.
Any Thoughts?
Thanks,
-Mike