Hi Folks,
I am seeking any advice on setup and tuneup of a new DeWalt 976 table
saw with optional cast iron wings. Specifically I want to know best
practices on measuring table flatness, fence square an parallel to miter
slots and blade/arbor runout.
Also, mentioned in one article I read in a magazine is a miter plane.
I have not really found any planes specifically advertised as miter
planes. Any pointers?
--
Joseph Crowe
For the table saw: http://www.ts-aligner.com
No idea about the miter plane.
Mike
--
There are no stupid questions.
There are a LOT of inquisitive idiots.
"Joseph Crowe" <[email protected]> wrote in message
news:[email protected]...
> Hi Folks,
>
> I am seeking any advice on setup and tuneup of a new DeWalt 976 table
> saw with optional cast iron wings. Specifically I want to know best
> practices on measuring table flatness, fence square an parallel to miter
> slots and blade/arbor runout.
>
> Also, mentioned in one article I read in a magazine is a miter plane.
> I have not really found any planes specifically advertised as miter
> planes. Any pointers?
>
> --
> Joseph Crowe
>