There is a demo part I made with cut3d. This is made from ipe with a
lot of bit overlap for a smooth finish. It still needs some sanding
but not a huge amount. It took about 1 hour to make it I used a ¼"
endmill to remove the bulk and then the final cuts were done with a
1/8 ball nose endmill. Its 10" long I think.
The inlay is done with 60 degree v cutting bit. A fellow came up with
this method as it is easier to do small pieces and you can get sharp
corners. I think I did not champ it tight enough and had a gap the
others I did were worse. It's that or the pieces moved while cutting.
When doing the inlay you're taking over a third of an inch off with a
vee bit. The wood needs to be held really tight.
http://www.knight-toolworks.com/cnc/inlay1.jpg
http://www.knight-toolworks.com/cnc/inlay2.jpg
http://www.knight-toolworks.com/cnc/inlay%20and%203d2%20(Small).JPG
http://www.knight-toolworks.com/cnc/inlay%20and%203d3%20(Small).JPG
http://www.knight-toolworks.com/cnc/inlay%20and%203d1%20(Small).JPG
On May 30, 10:03 pm, Steve knight <[email protected]> wrote:
> There is a demo part I made with cut3d. This is made from ipe with a
> lot of bit overlap for a smooth finish. It still needs some sanding
> but not a huge amount. It took about 1 hour to make it I used a =BC"
> endmill to remove the bulk and then the final cuts were done with a
> 1/8 ball nose endmill. Its 10" long I think.
> The inlay is done with 60 degree v cutting bit. A fellow came up with
> this method as it is easier to do small pieces and you can get sharp
> corners.
NICE!
I can't wait to try stuff like that myself.
On Thu, 31 May 2007 12:01:48 -0700, charlieb <[email protected]>
wrote:
>Steve:
>
>I take it business is good?
>
>Just remember - there are a LOT more CNC owners than there
>are plane makers. Anyone can run a CNC machine. Few have
>the skills and knowledge to make nice, very functional hand
>planes - that look and feel nice too.
I have not peddled the cnc machine yet too far behind on plane making
because of it (G) the cnc is not that easy there is a steep learning
curve and a lot of practice.
hope to make planes on it someday too but I bought it to bring in
outside work to my shop.