Depending upon the size of the piece, I'd consider using a circular saw and
guide...with a good rip blade. Practice to be sure your blade is lined up
with the sole (I have one that isn't and it binds up and burns every time!!)
Wilson
"keith" <[email protected]> wrote in message
news:[email protected]...
> I have a 1 3/4 inch butcher block top that i need to rip with a 3 hp
> cab saw,i only have a freud combo blade-will this work without burning
> too bad? Keith
keith wrote:
> I have a 1 3/4 inch butcher block top that i need to rip with a 3 hp
> cab saw,i only have a freud combo blade-will this work without burning
> too bad? Keith
Provided your saw is properly tuned and the blade is sharp it shouldn't be
a problem UNLESS you're looking to justify buying another blade. If that
be the case, ignore the previous statement and...
No! You need a new blade!
;-)
--
Jack Novak
Buffalo, NY - USA
(Remove "SPAM" from email address to reply)
"keith" <[email protected]> wrote in message
news:[email protected]...
> I have a 1 3/4 inch butcher block top that i need to rip with a 3 hp
> cab saw,i only have a freud combo blade-will this work without burning
> too bad? Keith
If the blade's sharp it shouldn't be much of a problem. Be sure to look
out for metal rods,etc. in the top (depending upon how it was
constructed)
Keith,
Be sure both the wood and blade are cleaned. Any residue on the blade will
heat up quickly and cause burning. Also make sure that your saw is in
alignment to avoid and skewing of the block as you push it thru. Avoid
pushing the wood to slow thru the blade. If you have any hardwood scraps to
practice on, that would give you a better feel for how fast.
I just finished making a 6' long maple threshold for a French door set and I
made a 9deg cut to make the bevel which went thru 3" of maple and only had a
small burn mark at the very last inch. Clean blade, good alignment and
nerves of steel !(oh, and did I mention, a good jig to hold the board
perfectly vertical thru the blade - till the last inch anyway...)
Bob S.
"keith" <[email protected]> wrote in message
news:[email protected]...
> I have a 1 3/4 inch butcher block top that i need to rip with a 3 hp
> cab saw,i only have a freud combo blade-will this work without burning
> too bad? Keith