Last night I finally got back to the December 2005 issue of
Popular Woodworking that Id put on the bedside table months
ago after glancing through it before heading off to the Arms
of Morpheus. Flipped it open to an article The Lost Arts & Mysteries -
Centuries-Old Secrets to Working Quickly and Efficiently
Two of The Lost Arts the author, Adam Cherubini, describes are great
examples of measuring without any pocket tape or machinist ruler. The
two terms used are gauging and slaving - utilizing the tools youre
working with.
Youve probably got a set of bench chisels - 1/4, 3/8, 1/2, maybe a
5/8, a 3/4 and maybe a one incher. Theyre usually on the behch, on a
shelf under the bench or somewhere near the bench - perhaps in a tool
cabinet a step or so from the bench. It doesnt matter if the 3/8ths is
in fact 0.375 inches, it could just as well be metric. The point is
that whatever the width, the width stays constant. If you want the
outside face of a mortised piece to line up with the outside face of the
tenoned piece - use the width of the chisel thats close to what would
be the theoretical ideal M&T location. Use a chisel as a gauge. No
misreading errors - if one edge is flush to the faces you want to line
up later and you scribe along the other side of the chisel, youre well
on your way to a nice joint. And it can be done by a blind man, or
woman.
And when you get to laying out the mortise and tenon - use the chisel
you have closest to ideal - the one youll be using to make the
mortise - to layout the mortise and tenon width. No tape required, no
ruler to misread - and no eye strain.
Two great examples of The Obvious - once theyre pointed out.
Theres also a paragraph or two on Tools Working Togeter - a striking
knive marking a line AND creating a fine groove in which to register a
chisel later. Again. No eye strain, no dedicated task lighting
required. You dont need to see the chisel edge on the line - you can
feel it.
Of course these secrets are mainly useful when using hand tools. Its
hard to feel when the cutting edge of a power tool encounters a scribed
layout line in the wood.
Some will say Thats nice - BUT - I make things using power tools.
Great. More power to you (pun intended). But at some point youre
going to want to fine tune the fit of a drawer or a part. Power tools
arent often easy to use when it comes to fine tuning - taking just a
hair off a surface, putting just a slight taper down a piece or a slight
bevel on a face. Eventually, youre going to get around to using hand
tools. And once you do youll understand better how some pretty nice
17th and 18th century pieces were done - before MORE POWER - precision
machinist ruler/rules.
Just something to think about - or not.
Charlie b