On Apr 9, 8:22 am, "Dr. Deb" <[email protected]> wrote:
> [email protected] wrote:
> > Help
> > I am new to wood working and the project I am making states to cut the
> > wood at a 1/8 inch off-set. How do I make this cut with a table saw?
>
> Like Morris said, "More information please." If you are brand new to
> woodworking you probably are unfamiliar with a lot of terms. Just describe
> what you think the plans are calling for. In fact it would be real nice if
> you could quote them.
>
> Deb
Thanks for the help.
The step reads " Bottom-should be cut to an 1/8inch offset to allow
for the angled sides
Sides-Bottom edges of sides should be cut to an 1/8 inch offset to
allow for a flat bottom"
On Apr 8, 7:53 pm, "Morris Dovey" <[email protected]> wrote:
> [email protected] wrote:
>
> | I am new to wood working and the project I am making states to cut
> | the wood at a 1/8 inch off-set. How do I make this cut with a table
> | saw?
>
> More information please. Can/would you describe what the finished cut
> is supposed to look like?
>
> --
> Morris Dovey
> DeSoto Solar
> DeSoto, Iowa USAhttp://www.iedu.com/DeSoto/solar.html
Thanks for the help.
The step reads " Bottom-should be cut to an 1/8inch offset to allow
for the angled sides
Sides-Bottom edges of sides should be cut to an 1/8 inch offset to
allow for a flat bottom"
[email protected] wrote:
| I am new to wood working and the project I am making states to cut
| the wood at a 1/8 inch off-set. How do I make this cut with a table
| saw?
More information please. Can/would you describe what the finished cut
is supposed to look like?
--
Morris Dovey
DeSoto Solar
DeSoto, Iowa USA
http://www.iedu.com/DeSoto/solar.html
[email protected] wrote:
> Help
> I am new to wood working and the project I am making states to cut the
> wood at a 1/8 inch off-set. How do I make this cut with a table saw?
Like Morris said, "More information please." If you are brand new to
woodworking you probably are unfamiliar with a lot of terms. Just describe
what you think the plans are calling for. In fact it would be real nice if
you could quote them.
Deb