The top of a teak Danish Modern style of dresser was scorched when a hot
clothes iron was left on it. A lot of the other furniture in the house
(living room and dining room) is also teak but from a much earlier era and
built with reasonably heavy veneers. Over the years I have successfully
sanded or steel-wooled out minor imperfections in the better-built units.
When I tried to sand out the scorch mark, the veneer was so thin I sanded
right through it to the base material.
Now we are considering reveneering the top. Years ago I had done a little
veneering on some small pieces that were to be used as serving pieces for
cakes and the like. I have also used Formica types of laminate to finish
kitchen counter tops so I am not a complete novice in the process.
The dresser top in question is 88' long and just under 18'' deep.
Looking through Google I came cross two sources of veneers that might fit
the bill.
Rockler has flexible sheets that are 2' by 8'. It is 1/64" thick, paper
backed with pressure sensitive adhesive.
Constantine's has flexible sheets that are 8' by 1.5' and 1/16". Their
description does not mention adhesive but refers to "glued down". They also
have the peel-n-stick that sounds like the Rockler product. Constantine's
recommends it is best finished with varnish or polyurethane. The rest of the
dresser and all the other pieces are oil finished.
I would like to get opinions on these products particularly if you have
actually used them. Self adhesive certainly sounds easier, but sure that
there must be downside I want opinions from users rather than the suppliers.
Charlie
"Charlie Bress" <[email protected]> wrote in
news:[email protected]:
> The top of a teak Danish Modern style of dresser was scorched when a
> hot clothes iron was left on it. A lot of the other furniture in the
> house (living room and dining room) is also teak but from a much
> earlier era and built with reasonably heavy veneers. Over the years I
> have successfully sanded or steel-wooled out minor imperfections in
> the better-built units. When I tried to sand out the scorch mark, the
> veneer was so thin I sanded right through it to the base material.
>
> Now we are considering reveneering the top. Years ago I had done a
> little veneering on some small pieces that were to be used as serving
> pieces for cakes and the like. I have also used Formica types of
> laminate to finish kitchen counter tops so I am not a complete novice
> in the process.
>
> The dresser top in question is 88' long and just under 18'' deep.
>
> Looking through Google I came cross two sources of veneers that might
> fit the bill.
>
> Rockler has flexible sheets that are 2' by 8'. It is 1/64" thick,
> paper backed with pressure sensitive adhesive.
>
> Constantine's has flexible sheets that are 8' by 1.5' and 1/16". Their
> description does not mention adhesive but refers to "glued down". They
> also have the peel-n-stick that sounds like the Rockler product.
> Constantine's recommends it is best finished with varnish or
> polyurethane. The rest of the dresser and all the other pieces are oil
> finished.
>
> I would like to get opinions on these products particularly if you
> have actually used them. Self adhesive certainly sounds easier, but
> sure that there must be downside I want opinions from users rather
> than the suppliers.
>
> Charlie
>
>
>
Get your product, and product support from Constantine's, when it comes
to veneers. It's their main product line. Rockler resells someone
else's stuff.
Top end furniture veneer is typically not paper-backed, self adhesive.
Patriarch