Anyone using a JDS 3hp cyclone?

eOn 21 Dec 2006 13:40:53 -0800, "Jack" <[email protected]> wrote:

>18 amps is full load current of the 3hp motor on the JDS cyclone. Jack

dc's suck a lot of power when they start. far more then most tools do.
mine really takes some power to get revved up to full power.

18 amps is full load current of the 3hp motor on the JDS cyclone. Jack

Full load current (amps) of a motor is the continuous loading of the
motor (ignoring service factor ) before overheating damage to the motor
will begin. Starting currents and duration are another rating that
depends on motor design and loading.

Full load current (amps) of a motor is the continuous loading of the
motor (ignoring service factor ) before overheating damage to the motor
will begin. Starting currents and duration are another rating that
depends on motor design and loading.

My 3hp cyclone is on a 25 amp breaker.

A 3hp 220 volt motor generally requires a 30a dedicated circuit. You
might be able to get by on a 20a circuit but you might blow the circuit
from time to time or overheat the wiring. 20a wiring is 12 gauge, 30a
is 10 gauge

Toller wrote:
> They say it draws 18a and can be run on a 20a circuit, but they suggest a
> 30a circuit.
>
> Until I get around to ripping all my cables out of my work shop and redoing
> them properly (I have already bought the subpanel...) I only have a 20a
> circuit, so I am wondering if it actually works.
>
> And, how do you like it in general? JDS actually said that for one machine
> their 2hp would be adequate, but I figure on something like a CMS you need
> all the air movement you can get.

Toller wrote:

> They say it draws 18a and can be run on a 20a circuit, but they
suggest a
> 30a circuit.

"They" don't have a clue if they suggest a 20A c'bkr.

You need 30A.

Thermal/Magnetic c'bkrs are designed to operate at 80% of rating on a
continuous basis under normal ambient temperatures.

Lew

In article <[email protected]>, Lew Hodgett <[email protected]> wrote:
>Toller wrote:
>
> > They say it draws 18a and can be run on a 20a circuit, but they
>suggest a
> > 30a circuit.
>
>"They" don't have a clue if they suggest a 20A c'bkr.
>
>You need 30A.

That depends on whether the 18A is peak, or continuous, current. If the
continuous current is 16A or less, a 20A breaker is fine. If it's over 16A,
then a 30A breaker is needed.
>
>Thermal/Magnetic c'bkrs are designed to operate at 80% of rating on a
>continuous basis under normal ambient temperatures.

Exactly -- which is why it's important to know whether the 18A is peak or
continuous.

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.