Such a plethora of wonderful advice and customary flames/disagreements.
Rick: I wish I had the space to put 'Bot in...and believe me, I can't
wait for the day, because it WILL happen. As always, thank you for your
input. (Morris is probably looking for Sterno tablets to fire up a
Stirling experiment...*G*)
Bottom line:
As always, you guys are the greatest source of information, bar none.
I almost lost my way when I suggested that I was interested in a low
cost alternative.
It's a couple-of-hundred smackeroonies. Period. *smacks self*
The Freud Dial-O-Matic appeals to me.So does the CMT pack.. Ridge is
not a good deal up here in Kanuckistan as is the Forrest...expensive.
Speed, simplicity of small adjustments makes that Dial-O-Job a good
choice for me. The materials I am using as 'shelves' varies by 1/32
plus/minus.... but that is usually over a whole sheet.
The flatness of the dado bottom is not as important to me as is the
accuracy of the width...but wobblers are too gross. (My ex was a
wobbler.. VERY gross. (sorry))
The routerbit solution would probably work just great if I didn't have
to make dados smaller than the smallest dado bit.
Again... thank you all so much.
Rob