I just put my new 16/32 together. Only had it stop twice so far... It does
require some real patience. But it doesn't seem to snipe at all if I am
careful to hold the board level at the end; so that is good news.
Anyhow, a board I sanded is 0.040" thicker on one side than the other, over
12". The instructions say to loosen two screws and tighten the fine
adjustment knob; but it doesn't even hint how much. Would 0.040" be a
quarter turn or 10 turns? All I am looking for is a ball park estimate.
Thanks.
Thought I had sent you this already but here ya go....
http://www.joewoodworker.com/performax.htm
Bob S.
"Toller" <[email protected]> wrote in message
news:[email protected]...
>I just put my new 16/32 together. Only had it stop twice so far... It
>does require some real patience. But it doesn't seem to snipe at all if I
>am careful to hold the board level at the end; so that is good news.
>
> Anyhow, a board I sanded is 0.040" thicker on one side than the other,
> over 12". The instructions say to loosen two screws and tighten the fine
> adjustment knob; but it doesn't even hint how much. Would 0.040" be a
> quarter turn or 10 turns? All I am looking for is a ball park estimate.
> Thanks.
>